EAW Resolution Specifikace stáhnout pdf (Strana 37)

EAW Smaart 6 Operation Manual Analysis Modes and Display Types

Chapter 3: Analysis Modes and Display Types

Smaart 6 has two analysis modes: Real-time and Impulse Response (IR Analysis). These

run in separate windows.

Real-time mode processes incoming data continuously and offers four display types:

RTA, Spectrograph, Magnitude, and Phase. RTA and Spectrograph displays are

considered Spectrum measurements, where each data set displayed is based directly

upon FFT data from a single signal. The Magnitude and Phase displays show Frequency

Response data based on the transfer function of two signals. Smaart 6 starts up with a

single-pane view with the RTA display type.

The Spectrum and Freq. Resp. buttons configure the real-time window with the two

displays corresponding to each of their respective measurement types:

• Click the Spectrum button to display a two-pane window with display types

set to Spectrograph (top) and RTA (bottom).

• Click the Freq. Resp. button to display a two-pane window with display types

set to Phase (top) and Magnitude (bottom).

Even if the single-pane View is selected, clicking the Spectrum or Freq. Resp. buttons

changes to a two-pane View. Of course, any display type can be subsequently selected.

Figure 3-1 View and plot display after clicking the Spectrum button

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 113 114

Žádné komentáře

EAW Resolution Specifikace Strana 37